Lennox Hearth ADAGIO-pF プリント

5. Install the facade onto the fireplace face per instructions in Figure 3.

6. See Figure 4 for instructions on accessing the control compart-

ment.

To access the control compartment, pull the hinged door

forward and up as shown. To close, hinge the door closed

until magnets secure it in place.

Figure 4 - Opening the Control Compartment Panel

Figure 5 - Completed Installation

IMPORTANT NOTE (Gold and Nickel Finishes Only): The gold

and nickel finishes will require heat to harden and cure (after

approximately 3 fires, the finish will be completely cured). Prior

to burning this appliance the gold and nickel surfaces should be

cleaned thoroughly with a good window cleaning solution and a

soft cloth. Do not use any metal polishes or abrasives to clean

the surfaces. Any oils or fingerprints left on the finish during the

curing process may become permanent blemishes.

Magnets

Control Compartment

Control Compartment Panel

Facade

3. Using a 3/8” socket or nutdriver, install the upper filigree inset, lower

filigree inset, screen and screen retainer with provided washers and

nuts as shown in Figure 2. Note: you will have four extra washers

and nuts.

4. Reinstall heat shield aligning the top corners of the heat shield with

the etch marks in the back of the facade for proper placement. Do not

over tighten nuts.

Figure 2

Brushed Nickel

Facade Shown

Figure 3 - Install Facade

Tabs on Bracket

Assemblies (2

places each side)

Slots on Fireplace

(2 places each side)

Facade

Align the tabs on the

bracket assemblies all

the way into the slots

on fireplace, then push

facade down to ensure

engagement.

p/N 750,231M REV. NC 06/2008

Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and the discontinuance of colors, styles and products.

Consult your local distributor for fireplace / insert code information.

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

Lennox hearth products

1110 west Taft Avenue • Orange, CA 92865

Note: There are two mount-

ing positions on the facade

hanging brackets to better

accommodate a range of

facing thicknesses. Adjust

to the notch on the hanging

bracket that works best for

your installation.

heat Shield

Upper Filigree

Lower Filigree

Screen

Screen Retainer

Etch

Marks