Lennox Hearth AKT-DV プリント

HeartH products

KIts aNd accessorIes

printed in u.s.a. © 2009 by Lennox Hearth products

the manufacturer reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. 

consult your local distributor for fireplace code information.

Note: dIaGraMs & ILLustratIoNs Not to scaLe.

2 - andirons, 4 - attaching screws and these instructions.

TOOLS NeeDeD - 

phillips Head screwdriver.

Step 1. Follow the procedure "turning off Gas to unit", located on 

the Lighting Instructions pullout labels in the control compartment of 

the unit and in the Installation Instructions (p/N 506023-08) provided 

with the appliance.

Step 2. refer to the appliance care and operations Instructions (p/N 

506025-01) to remove the front glass enclosure panel and gain ac-

cess to the firebox interior. 

Step 3.  align the holes on the andiron brackets, with the holes 

on the fireplace sub-floor and attach the andiron with the provided 

attaching screws (see Figure 1 ).  It is recommended that two (2) 

screws be used for each andiron, however one (1) screw may be 

used, depending on placement of the andiron.

Step 4.  place all Lava rock and rockwool according to the appliance 

care and operation Instructions (p/N 506025-01).

Step 5.  refer to the appliance care and operations Instructions (p/N 

506025-01) and re-install the front glass enclosure panel.