Monessen Hearth NB18 ユーザーズマニュアル

ページ / 40
81D0107 
5
MAKE SURE YOU HAVE RECEIVED ALL PARTS:
Check your packing list to verify that all listed parts have been received. You should have the following:
  •  Unvented Gas Log Burner Assembly 
•  Two (2) Plastic Bags Containing Crushed Volcanic Rock 
  •  Installation/Operating Instructions 
•  Two (2) Anchoring Screws
  •  Ceramic Fiber Logs / Refractory Logs 
•  Rock wool
  •  Grate Assembly 
•  On/Off Log Switch Assembly 
The following options may be used with the Millivolt controlled heater. These options are not packaged with the log 
set.
  •  Hand Held Remote with Receiver 
•  Wall Thermostat with 15' Wire
  •  Wall Switch with 15' Wire 
•  Hand held Thermostat Remote with Receiver
  •  Cast Iron Grate and Andirons   
•  Riser Kit
Gloves are recommended when 
handling ceramic fi ber logs to prevent 
skin irritation from loose fi bers. Logs 
are fragile — handle with care.
CAUTION
Carefully inspect the contents for shipping damage. If any parts are missing or damaged, immediately inform the dealer 
from whom you purchased the appliance. Do not attempt to install any part of the appliance unless you have all parts 
in good condition.
WHAT YOU WILL NEED FOR INSTALLATION:
You should have the following items available before proceeding with installation:
  •  External regulator (for propane/LPG and 1/2 lb. natural gas systems only)
  •  Piping which complies with local codes 
•  Sediment trap (recommended) 
  • Screwdriver 
• Tee joint.
  •  Pipe sealant approved for use with propane/LPG (Resistant to sulfur compounds) 
  •  Drill with 5/32 masonry bit  
•  Pipe wrench or appropriate size crescent wrench set 
  •  Manual shutoff valve
GETTING STARTED