Empire Comfort Systems CIVF-25-21 ユーザーズマニュアル

Page 14

16938-3-0806

Before operating this heater, please review the safety warnings

pages at the beginning of this manual and those precautions and

warnings listed below.

1. Know what type of ignition system this model has (standing

pilot) and follow the applicable SAFETY and LIGHTING

instructions.

2. Check to ensure there are no gas leaks. If you are unsure, turn gas

off to the heater and call a service person or your gas utility.

CAUTION: Clothing or other ﬂammable material should not

be placed on or near the appliance.

WARNING: Children and adults should be alerted to the

hazard of high surface temperature and should stay away

to avoid burns or clothing ignition. Young children should

be carefully supervised when they are in the same room as

the appliance.

3. Tampering is DANGEROUS and voids all warranties. Any

component that is found to be faulty, must be replaced with an

approved component.

Initial Lighting (Figure 14)

Upon completing the gas line or turning the gas valve "ON" after it

has been in the "OFF" position, a small amount of air will be in the

lines. When ﬁrst lighting the appliance, it will take a few minutes

for the lines to purge themselves of this air. Once the purging is

complete, the appliance will light and operate satisfactorily.
Subsequent lightings of the appliance will not require such purging

if the gas valve is not turned to "OFF."
Standing Pilot Operation

1. Follow the SAFETY and LIGHTING INSTRUCTIONS for

standing pilot controls found in this manual and on labels found

attached to the appliance.

CAUTION: During the initial purging and subsequent lightings,

never allow the gas valve control knob to remain depressed in

the "pilot" position without pushing the piezo ignitor button

at least once every second.
2. D u r i n g t h e

heating season,

leave the control

valve knob in the

"ON" position.

This will allow

the pilot ﬂame

to remain lit.

Turn the burner

ﬂame on or off with the

appliance ON/OFF rocker

switch, wall switch, remote control kits or 750 millivolt wall

thermostat.

NOTE: The gas control valve allows you to increase or decrease the

height of the main burner ﬂame. The control valve has a pressure

regulator with a knob as shown in Figure 14. Rotate the knob

clockwise to "HI" to increase the ﬂame height and counterclockwise

to "LO" to decrease the ﬂame height.
3. When the heating season is over, turn the on/off switch to "OFF"

and the control valve to "OFF". The system, including the pilot

light, will be shut down.

Maximum and Minimum Input

The gas valve on the appliance allows the input to adjust between

a maximum input of 30,000 to a minimum input of 21,000 Btuh.

Please be advised, the maximum input provides the greatest amount

of yellow ﬂame and ember glow on the log set. The minimum

input substantially decreases the yellow ﬂame and ember glow

on the log set.

LOG PLACEMENT

1. Remove screen front from inner body by removing (2) 10 x

1/2" screws.

2. Remove logs from interior of ﬁrebox. Remove all protective

packaging from logs and interior of ﬁrebox.

3. Place front log onto two (2) front pins on inner bottom.

4. Place rear log onto two (2) rear pins on rear log support.

5. Place top log onto two (2) pins on rear log.

6. Replace and attach screen front onto inner body with (2) 10 x

1/2" screws from Step 1.

7. Log placement is completed.
Refer to Figure 13 for the following warning.

Warning: Failure to position the parts in accordance with this

diagram or failure to use only parts speciﬁcally approved with this

appliance may result in property damage or personal injury.

OPERATING GUIDELINES

Figure 13

Figure 14