Hampton Direct H25-LP1 ユーザーズマニュアル

Hampton

®

 H25-1 Direct Vent Freestanding Gas Stove

33

3)  Install 3 AAA alkaline batteries in transmitter 

and 4 AA alkaline batteries in  the receiver. 
Install the receiver and its cover in the wall. 
Switch the  remote receiver to "remote" 
mode. The remote control is now ready for 
operation.

Use the Hampton

®

 Remote Control Kit approved 

for this unit. Use of other systems may void 
your warranty.

The remote control kit comes with a hand held 
transmitter, a receiver and a wall mounting 
plate.

1)  Choose a convenient location on the wall 

to install the receiver and the receptacle 

A wall thermostat may be installed if desired. 
Connect the wires as per the wiring diagrams. 
Note that the wires are  connected to the "TH" 
on the gas valve. Use table below to determine 
the maximum wire length:

Hampton

®

 offers an optional programmable 

thermostat but any 250-750 millivolt rated non-
anticipator type thermostat that is CSA, ULC or 
UL approved may be used.

14 GA.
16 GA.
18 GA.
20 GA.
22 GA.

50 Ft.
32 Ft.
20 Ft.
12 Ft.

9 Ft.

Wire Size                       Max. Length

1)  Turn the Grill Latches on the Rear of the 

Door Grill as per the photo below.

2)  Place the Door Grill into the Cast Front. 

Secure the Door Grill by turning the Grill 
Latches inward, between the glass and the 
Cast Front.

box (protection from extreme heat is very 
important). Run wires from the fi replace to 
that location, use Thermostat Wire Table.

2)  Connect the wires as per the wiring diagram 

below.