Makita DBC4010 ユーザーズマニュアル
16
Putting into operation
-
Move the switch (G/6) in the direction of the arrow.
-
To set the half-throttle catch, press the throttle (G/8) with
the throttle trigger lockout (G/7) pressed and then press
the catch (G/10). Release the throttle (G/8) and then the
throttle trigger lockout (G/7).
the throttle trigger lockout (G/7) pressed and then press
the catch (G/10). Release the throttle (G/8) and then the
throttle trigger lockout (G/7).
Cold start
H
-
Turn the choke lever (H/9) downwards to choke the engine.
9
I
-
Hold the brushcutter frimly down with one hand, as
illustrated above.
illustrated above.
-
Pull the starter handle out slowly until resistance is noticed,
then pull the starter handle out fully with a quick and forceful
movement.
then pull the starter handle out fully with a quick and forceful
movement.
-
Do not pull out the whole starter cable to its full extent and
do not let the starter handle jump back, but let it slowly
automatically rewind itself.
do not let the starter handle jump back, but let it slowly
automatically rewind itself.
-
Repeat starting procedure until ignition is achieved.
-
Turn the choke lever (H/9) back up and pull the starter
cable again until the engine starts.
cable again until the engine starts.
-
After the engine has started, press the throttle (J/8) all the
way in and release immediately. This will disengage the
half-throttle position.
way in and release immediately. This will disengage the
half-throttle position.
-
Run the engine for approximately 1 minute at a moderate
speed before commencing work.
speed before commencing work.
Warm start
Similar to a cold start but without the choke.
Turning off the engine
Move switch (J/6) to the position .
STOP
Observe accident-prevention regulations!
Do not start the brushcutter until fully assembled and
inspected!
inspected!
Starting the engine
-
Move at least 10 feet (3 meters) away from where you filled
the fuel tank.
the fuel tank.
-
Make sure you have a good footing, and lay the brushcutter
on the ground in such a way that the cutting tool is not
touching the ground or anything else.
on the ground in such a way that the cutting tool is not
touching the ground or anything else.
G
8
6
7
10
J
6
8