DeLonghi PACL90 ユーザーズマニュアル

5

The instructions below will enable you to prepare your air conditioning unit for operation as effi-
ciently as possible.

Just a few simple steps and your comfort is
ensured with Pinguino:

•

Fit the air exhaust hose 

in the housing

at the back of the appliance. Insert it as

shown in figure A.

In order to improve the performance of the
appliance in air conditioning and boost
(super-conditioning) modes, you can also fit
the intake hose accessory 

in its housing in

the back of the appliance  as shown in figure
A1. This step is optional.

•

Fit the window outlets 

to the end of

the hose 

/ 

.

•

Place the air conditioning unit near a win-
dow or French window.

•

Make sure the air exhaust hose is unob-
structed. 

Keep air hoses as short and free of cur-
ves as possible to avoid constrictions.

ELECTRICAL CONNECTIONS
Before plugging the appliance into the electrical socket, check that:
•

the  power supply corresponds to the value indicated on the rating plate on the back of the appliance;

•

the  socket and electrical circuit are adequate for the appliance;

•

the  socket matches the plug. If this is not the case, have the plug replaced;

•

the  socket is adequately grounded. Failure to follow these important safety instructions absolves the manu-
facturer of all liability.

For optimum results:

•

If you have a sash window, place the
bracket or according to your
needs,  on the window sill, extend the
bracket fully within the window frame, fix the
bracket by using the pin then lower the win-
dow onto the bracket. Insert the window
outlet 

of the exhaust hose 

into the

slot, then connect the hose to the air condi-
tioner (fig. B and B1).

Thanks to the locking pins, it’s possible to use
the window bracket also for sliding windows.
Position the hole of the bracket so to allow a
correct installation of the exhaust hose.