Frigidaire FRA123PT1 ユーザーズマニュアル

9

2009 Electrolux Home Products, Inc.

All rights reserved.

During dehumidifying mode, remove the supplied rubber stopper from the 
hose connector. Screw a suitable length of hose onto this connector. Place 
the open end into a suitable drain, and make sure there are no kinks in the 
hose. (Fig.23)

The door on side of the unit is for storing the remote, to open press it as 
shown in Fig. 24, to close simply push it back into position.

Continuous
drain hose

Remove the 
drain plug

When you turn on the unit, the louver will swing and stop at a certain angle. You 
can press the SWING button to let the louver swing automatically. Press the 
SWING button again while you want the louver stop at desired angle.

This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more 
efficient operation. The LED (light) which above the "Filter" button will illuminate 
after 250 hours of operation. To reset after cleaning the filter, press the "Filter" 
button and the light will go off.

If the display reads "EA" , the room temperature sensor has failed. Contact your Authorized 
Frigidaire Service Center.

If the display reads "ES" , the evaporator temperature sensor has failed. Contact your  
Authorized Frigidaire Service Center. 

If the display reads "E4" , the display panel communication has failed. Contact your 
Authorized Frigidaire Service Center.

If the display reads "P1" , bottom tray is full.  Carefully move the unit to a drain location, remove 
the bottom drain plug and let the water drain away. Restart the machine until the "P1" symbol 
disappears. If error repeats, call for service.

Press here