Frigidaire FFRE1033Q1 ユーザーズマニュアル

10

2009 Electrolux Home Products, Inc.

All rights reserved.

Now that you have mastered the operating procedure, here are more features in your control that you should become familiar with.

The "Cool"  circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. 

This prevents overheating of the compressor and possible circuit breaker tripping. The fan will continue 

to run during this time.

The control will maintain the set temperature within 2 degrees Fahrenheit, between 60F and 90F degrees.

There is a 2-Second delay for the compressor shutting down when selecting FAN ONLY. This is to cover the possibility of having 

to roll through to select another mode.

After a power outage, the unit will memorize the last setting and return the unit to the same setting once power is restored.

The Fresh Air Vent allows the air conditioner to:

1.  Recirculate inside air - Vent Closed (see Fig. 1)

2.  Draw fresh air into the room - Fresh Air (see Fig. 2)

3.  Exchange air from the room - Vent Open (see Fig. 3)

Figure 1 (VENT CLOSED)

Figure 2 (FRESH AIR)

Figure 3 (VENT OPEN)

PRESS 

ON/OFF BUTTON

(8-WAY)

Air directional louvers control air flow direction. Your air conditioner has the louver

type described below.

The louvers will allow you to direct the air flow Up or Down and Left or Right 

throughout the room as needed. Rotate the Auger Wheels until the desired 

Left/Right direction is obtained. Pivot horizontal louvers until the desired 

Up/Down direction is obtained.

AUGER WHEELS

Note: If the unit is turned off in heat mode (if applicable) or 

fan only mode, it will return to the same setting when it is 

turned on again. When the unit is turned off in cool or energy 

saver(econ) mode, it will run in energy saver(econ) mode 

when it is turned on again, but the setting of temperature 

and fan speed will remain.