Frigidaire 2020213A0362 ユーザーズマニュアル

Open the window the maximum amount to 

allow for clearance of the cabinet. The crank handle 
should be removed to allow the platform to be 
fastened to the jamb. If the window cannot open far 
enough (more than 15-1/2 inches) for the cabinet to 
clear the window, remove the window entirely by 
drilling out the rivets. Bolts can serve as the pivots in 
the future.

To avoid crank handle and window clearance 
problems, the unit can be installed in a stationary 
sash section. However, the horizontal mullion and the 
2 glass panels must be removed before installation.

1. Attach support brace to platform as shown. Use 
the adjustment bolt and hex flange nut to complete 
the assembly. Choose the slot and adjustment bolt 
hole locations that will create a 45 degree angle 
between the platform and the support brace. Try the 
assembly in the window to determine if the platform 
will rest properly, and allow the proper slope (3/16-
inch lower on outside).

 If you are planning to use a siding-

protection board (see Step 6) on the outside of your 
house, hold the board in place when testing the 
assembly in the window.

2. Drill a 9/64-inch diameter pilot hole in the 
window jamb an equal distance from each side of the 
jamb, and 3/16-inch up from the window sill. If the 
hole coincides with the window lever slot in the jamb 
bottom, an additional hole will have to be drilled 
through the platform edge and the window jamb to 
miss this slot.

3. Peel off the protective backing from the track 
seal, and stick the seal to the window sill on the 
outside of the bottom jamb.

4. Screw the platform assembly to the window 
jamb through the pilot hole you drilled in Step 2. Use 
a #8x3/4-inch self-threading screw. (continued)

Platform Assembly

1

/ " (6mm) HEX FLANGE NUT

4

11

8 / inches

16

Equal distance from both sides

Apply track seal to the outside
edge of the bottom window jamb.

8

Screw

Track seal

Window
jamb