Friedrich SV12 ユーザーズマニュアル

—9—

1. Remove the cabinet. (Refer to section 2.1.2)
2. Remove the turbo fan. (Refer to section 2.2.1)
3. Remove the fan. (Refer to section 2.2.2)
4. Remove the 4 screws which fasten the motor from

the Motor Mount. (See Figure 15)

5. Remove the motor.
6. Re-install the components by referring to the

removal procedure, above.(See Figure 15)

1. Remove the cabinet. (Refer to section 2.1.2)
2. Remove the 4 screws which fasten the brace.
3. Remove the 4 screws which fasten the condenser

and shroud. (See Figure 16)

4. Remove the 2 screws which fasten the condenser

and base pan.

5. After discharging the refrigerant completely,

unbraze the interconnecting tube at the condenser
connections.

6. Remove the condenser.
7. Re-install the components by referring to notes on

p10. (See Figure 16)

1. Remove the cabinet. (Refer to section 2.1.2)
2. Remove the control box.(Refer to section 2.1.3)
3. Remove the upper air guide. (Refer to section

2.2.1)

4. Remove the 2 screws which fasten the evaporator

to the lower air guide.

5. Carefully move the evaporator sideways.

(Refer to section 2.2.1)

6. After discharging the refrigerant completely,

unbraze the interconnecting tube at the evaporator
connections.

7. Remove the evaporator.
8. Re-install the components by referring to notes on

page 10. (See Figure 17)

Discharge the refrigerant system using a
Freon

TM

Recovery System.

If there is no valve to attach the recovery 
system to install one (such as a WATCO A-1)
before venting the Freon

TM

. Leave the valve in

place after servicing the system.