Friedrich 920-087-09 ユーザーズマニュアル

19

1.  Remove front panel. See Figure 22.
2.  Remove junction box.

• 

Remove junction box cover by removing three screws from 

front. Remove junction box by taking out top, rear and side 

screws. See Figure 24.

Failure to follow this warning could result in
personal injury or death and/or unit damage.

Follow the National Electrical Code (NEC)
or local codes and ordinances.
For personal safety, this unit MUST BE
properly grounded.
Protective devices (fuses or circuit breakers)
acceptable for unit installations are specified
on the nameplate of each unit.
Do not use an extension cord with this unit.
Aluminum wiring in the building may present
special problems - consult a qualified
electrician.
When unit is in STOP position, there is
still voltage to the electrical controls.
Disconnect power to unit before servicing by:
1. Removing power cord (if it has one) from
    wall receptacle.
2. Removing branch circuit fuses or turning
    circuit breakers off at panel.

FRP017

UNIT
CONNECTOR

JUNCTION BOX

JUNCTION BOX COVER

FRP018

ACCESSORY
POWER SUPPLY CORD
OR HARD WIRE

3.  Connect accessory power supply cord or hard wire connector to 

unit connector. See Figure 26.

• 

Units must be installed using the appropriate power supply  

kit. See Table 2 --POWER CONNECTION CHART. These 

connections must be followed.

See Table 2 on page 14 for power cord accessory options and ratings.

4.  Reinstall junction box and cover.

• 

Use wire clamp to attach power cord to basepan. Secure 

with screws (included) See Figure 27.

• 

Replace junction box and cover with screws removed from 

Step 2. Tighten securely.

5.  Replace front panel. See Figure 24.
6.  Connect power to unit.

FRP019

WIRE CLAMP