Friedrich 920-087-09 ユーザーズマニュアル

22

The vent control lever is located on the left side of the unit, behind the 

front panel.

NOTE: 

The vent door shipping hardware must be removed before 

using the vent control lever.  See page 17, Figure 21, (Remove 

Shipping Screw from Vent Door if present).

When vent door is set to CLOSE, only the air inside the room is circulated 

and filtered, See Figure 28.
When vent door is set to OPEN, some outdoor air will be drawn into room.

This may reduce heating or cooling efficiency.

To adjust air direction:

1.  Remove front panel. See Figure 22.
2.  Remove louver screws that hold louver insert in place (from back 

side of front panel). See Figure 29.

3.  Turn louver insert and rotate 180°. See Figure 30.
4.  Replace louver insert.
5.  Replace screws and front panel.

FRP025

VENT CONTROL
(Pull lever through
label to operate)

CLOSED

OPEN

FRP026

LOUVER SCREWS

FRP027