Friedrich 920-087-09 ユーザーズマニュアル

New Construction Accessories

PDXWS

PDXWSEXT

WALL SLEEVE Galvanized zinc coated steel is prepared in an 11-step process,

then powder coated with a polyester finish and cured in an oven for exceptional

durability. The wall sleeve is insulated for sound absorption and thermal ef-

ficiency, 16" High x 42" Wide x 13 3/4" Deep.

DEEP WALL SLEEVE EXTENSION For use when the wall is thicker than 13

1/4”deep. The wall sleeve may be special ordered through your Sales Represen-

tative and will be cut to your specific depth requirements..

PXGA

GRILLE Standard, stamped aluminium, anodized to resist chalking and oxidation.

PXAA

PXBG

PXSC

ARCHITECTURAL GRILLES Consist of heavy-gauge 6063-T5 aluminum alloy:

PXAA – Clear, extruded aluminum

PXBG – Beige acrylic enamel

PXSC – Also available in custom colors.

PXDR10

CONDENSATE DRAIN KIT Attaches to the bottom of the wall sleeve for internal

draining of condensate or to the rear wall sleeve flange for external draining.

Recommended on all units to remove excess condensate. Packaged in quantities

of ten.

PXSB

DECORATIVE SUBBASE Provides unit support for walls less than six inches

thick. Includes leveling legs, side filler panels and mounting brackets for electri-

cal accessories. Accepts circuit breaker, power disconnect switch, or conduit kit.

RT6

DIGITAL REMOTE WALL THERMOSTAT Single stage cool, single stage heat

for PDE models or single stage cool, dual stage heat for PDH model thermostat

features high/low fan speed switch. Thermostat is hard wired and can be battery

powered or unit powered. Features backlit display and multiple configuration

modes. For use on PD-series Friedrich PTACs and Vert-I-Paks.

PDXRT

REMOTE THERMOSTAT ESCUTCHEON KIT This kit contains ten escutcheons

that can be placed over the factory control buttons when a remote wall mounted

thermostat is used. The escutcheon directs the guest to the wall thermostat for

operation and retains the LED window to display error codes and diagnostic

information.

PXSE

SLEEVE EXTENSION RETROFIT KIT Galvanized zinc coated steel, 2.4" sleeve

extension attached to the room side of the sleeve to allow for the installation of a

PD-Series Friedrich PTAC in a T-Series sleeve.

PDXDAA

LATERAL DUCT ADAPTER Attaches to the PTAC/PTHP unit and provides a

transition to direct up to 35% of the total CFM to a secondary room, either left or

right of the unit. Kit includes duct plenum with discharge grille and internal baffle,

adapter and end cap.

PDXDEA

LATERAL DUCT EXTENSION A three-foot insulated plenum that attaches to

the left or right side of the duct adapter. The extension can be cut to length by the

installer. Maximum allowable straight extension is 15 feet.

Accessories

FRP029