Energy Tech Laboratories 40 Series ユーザーズマニュアル

 CLEAN THE FLUEWAYS (See Figure 28).

1.  Disconnect oil line(s) and remove burner and burner

mounting plate. See Figures 1A thru 1D.

2.  Lay protective cloth or plastic over combustion

chamber blanket.

3.   Remove the smokepipe as necessary to gain access

to the boiler canopy.

4.  Remove the jacket top panels.

5.  Remove the canopy being careful not to damage the

cerafelt gasket.

6.  Using a 1¼” diameter wire or fibre bristle brush

(30” handle) clean the flueways. Brush from the top
using diagonal strokes for best results. DO NOT
allow brush to strike the target wall or liner in the
chamber.

 CLEAN TOP OF BOILER SECTIONS.

1.  Brush and vacuum the tops of the boiler sections.

 CLEAN THE FIREBOX.

1.  Using wire or fibre bristle brush, clean crown

of boiler and inside of water legs. DO NOT
allow brush to strike target wall or blanket in the
combustion chamber.

 AFTER CLEANING, remove protective cloth with

debris and vacuum as necessary, but be careful not

to damage blanket. Inspect target wall, combustion
chamber blanket and burner mounting plate insulation

for signs of damage. If damaged, replace as needed.

REASSEMBLE BOILER.

Do not start the burner unless canopy,

smokepipe and burner swing door are secured in place.
1.  Install the canopy taking care to align the gaskets

without blocking the flueways. If gasket is damaged,
replace as needed.

2.  Close and secure burner swing door to front section

with fasteners.

3.  Reconnect oil line(s).

4.  Reinstall Top Panels and secure with sheet metal

screws.

5.  Reinstall smokepipe on canopy and secure to collar

with sheet metal screws.