Lopi Endeavor ユーザーズマニュアル

Optional Equipment

100-01161

4040608

Attach the retainer to the shell following the directions below.

AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA

Make sure the door retainer is centered on the door shell.

You can gauge the alignment by looking at the gaps here.

Once the door is aligned, tighten

the two set screws on the bottom

of the door shell to secure the

door retainer.

1/8” Hex Wrench

Attach the door handle
following the directions to
the right.

Replace the door on the
hinges and latch the door.

Attach the ashlip trim
following the directions
below.

9/16" Wrench

AAAAAAAAAAAAA

NOTE: in rare cases the door retainer may not line up with

the door shell, preventing the door handle from lining up

correctly. To adjust the position horizontally, loosen the set

screws (see step 3) and adjust the door retainer position. To

adjust vertically, remove the retainer and adjust the clips on

the door shell (see step 2).

Slide the ashlip trim into place then tighten the three

set screws on the bottom of the ashlip to secure.

1/16” Hex Wrench