Martin Fireplaces VFCS20SNV ユーザーズマニュアル

24 

1.  Ignitor electrode positioned wrong.

2.  Ignitor electrode is broken.

3.  Ignitor  electrode  not  connected  to  ignitor 

cable.

4.   Ignitor cable pinched or wet. Keep ignitor cable 

dry.

5.  Broken ignitor cable.

6.  Bad piezo ignitor.

7.  No battery power (auto spark).

1.  Appliance  burning  vapors  from  paint,  hair 

spray, glues, etc.

2.  Gas leak.

3.  Initial burn off. 

1.  Not enough fresh air is available for ODS/ pilot 

to operate.

2.  Low line pressure.

3.  ODS/pilot is partially clogged.

4.  Defective Thermopile.

5.  Restrictions in incoming air flow. 

1.  Gas leak.

2.  Control valve defective.

1.  Gas  supply  turned  off  or  appliance  shutoff 

valve closed.

2.  Air in gas lines when installed.

3.  ODS/pilot is clogged.

4.  Gas regulator setting is not correct (LPG).

1  Replace ignitor.

2.  Replace ignitor.

3.  Reconnect ignitor cable.

4.  Free  ignitor  cable  if  pinched  by  any 

metal or tubing.

5.  Replace ignitor cable.

6.  Replace piezo ignitor.

7.  Replace battery. 

1.  Ventilate room. Stop using odor causing 

products while heater is running.

2.  Locate and correct all leaks.

3.  Ventilate room and turn unit on high until 

odor is gone. Odor should be gone after 

2 to 3 hours of continuous use. 

1.  Open window and/or door for ventila-

tion.

2.  Contact local gas company.

3.  Clean ODS/pilot.

4.  Check pilot flame. Check wire connec-

tions. Check thermopile output — should 

be 500 milli-volts across TH/TP and TP 

Terminals with ON/OFF switch off.

5.  Check for obstructions on bottom of unit. 

Check for improper log placement.

1.  Locate and correct all leaks.

2.  Replace control valve.

1.  Turn  on  gas  supply  or  open  manual 

shutoff valve.

2.  Continue holding down control knob. 

Repeat  igniting  operation  until  air  is 

removed.

3.  Replace ODS/pilot assembly or get it 

serviced.

4.  Replace gas regulator at tank.