Regency C33-NG3 ユーザーズマニュアル

8

Regency

®

 CLASSIC C33-3 Freestanding Gas Stove

1)  For easier assembly, tip the stove on its back 

(preferably onto a soft surface to prevent 
scratching).

  
2)  Unscrew the 4 bolts in the underside of the 

stove. Align the holes in the corners of the 
pedestal top with the corresponding holes in 
the base of the stove.  Use washers which 
are supplied with the pedestal as shown in 
diagram. Reinstall bolts.

11)  Remove the dummy plug from the right side 

of the bottom shield or pedestal and install 
the supplied fan switch.

12) Attach hot wire from power cord to the ther-

modisc.

13) Slide the thermodisc under the bracket.

16) Pull power wire back and put strain relief 

grommet in place as per diagram 4.

17) Reverse steps 3-1 to complete installa-

tion.

 

 Note: The #8 ground lug is a dedicated 
ground for mobile home use only.

 

 

 

Only C34 unit is approved for mobile 
homes.

1)  Disconnect the power to fan.

2)  Allow the stove to cool to room tempera-

ture.

3)  Open the pedestal door  and remove the 

screws on the door cover plate. Leg Units: 
Remove bottom access panel.

4)  Loosen the nutsert screws.

5)  Remove Fan Assembly from the key slots 

at the fan base. Take the fan out from the 
rectangular opening . Diagram 3.

6)  Turn the fan around 90 degrees (Pedestal 

units only). Diagram 2.

7)  Disconnect the green ground wires to the 

grounding lug.

8)  Disconnect the white wire of the fan from 

the power cord.

9)  Disconnect red wire and black wire (from 

fan to Fan Switch).

10) Take fan out from the stove body. Diagram 

14) Connecting wires to the 3 way switch - 
 a.  Connect the red wire from the fan to the 

top of the 3 way switch.  

 b. Connect black wire from fan to the bottom 

of the 3 way switch.

 

c. Connect white jumper wire to middle of 
the three way switch. See wiring diagram 
below. 

15) Connect white wire from fan motor to neutral 

on the power cord.

3)  Hook up wires to Burner ON/OFF switch 

and valve assembly (be careful not to pinch 
wires). See Diagram 1.

4)  Push the Regency

®

 logo into the two holes 

in the front bottom left corner of the pedestal 
cover plate.

 
Note:   Any paint touch up should be done