Regency F38-LPG2 ユーザーズマニュアル

Regency F38-2 Freestanding Gas Heater

4)  Remove the two outside frame pieces by 

removing two screws per side.  See diagram 
below.

If your valve requires maintenance or replace-
ment, follow these instructions:

1)  Open front pedestal door and unhook chain. 

You may want to put a soft cloth on the base 
of the unit so that when the pedestal door 
is open it doesn't scratch the paint.  See 
diagram below.

2)  Undo the six screws holding the control 

panel in place.

3)  Disconnect all wires from the back of the 

panel and then remove panel.  You should 
lay the panel on a soft cloth so it doesn't get 
marked up.  See diagram below.

5)  Carefully remove the logs and lava rock.

6)  At this point you should disconnect the gas 

at the valve. 

7)  Remove the burner by removing the two
 

1/4" hex head screws. See diagram be-
low. 

9)  Carefully lift the burner tray assembly out.

8)  Remove eight 1/4" hex head screws holding 

the burner tray assembly in place.

10) To replace the burner tray assembly, simply 

reverse these instructions.