Regency U38-NG ユーザーズマニュアル

Regency U38 ULTIMATE Freestanding Gas Heater

3) Place Rear Log A)02-65 on the two pins on

the rear log support.

4) Place the Middle  Left Log B)02-56 on the

two pins as shown.

5) Sprinkle some lava rock just in front of B)

02-56 on the burner holes.

6) Place Front Left Log C)02-44 onto the 2

front pins as shown.

7) Place the Left Top Log D)02-46 on the pin

on Log  B)02-56 and on top of the cutout on
Log A)02-65.

8) Place Front Right Log E)02-45 on the two

pins as shown.

9) Place  the lava rock in the area between the

left and right logs, leaving a space in the
middle for log (F) 02-47.

10) Place the notch in Center Log F)02-47 over

Log E)02-45 and across the cutout on Log
A)02-65.

11) Position notch in Front Right Log G)02-48

on Log F)02-47 and push the bottom right
edge against the bracket on the burner
tray.

12) Test fire to ensure proper light off (make

sure flame flows smoothly from one end of
burner to the other.  If there is any flame
hesitation, check that area for any block-
age of the burner port.