Regency U37-LP PROPANE ユーザーズマニュアル

16

U37 Regency ULTIMATE Rear Vent Direct Vent Freestanding Gas Heater

Conversion Kit from Natural Gas to Propane

Conversion Kit # 680-969 Contains:

Qty. Part #

Description

1 910-018

SIT Conversion Kit-
50% Turndown LP

1 910-037

LP Injector (Pilot Orifice)

1 904-390

Burner Orifice #52

1 908-528

Red "PROPANE" label

1 908-255

Label "Converted to Propane"

1 918-031

Instruction Sheet

1) Shut off the gas supply.

2) Open the front door and carefully remove

the logs and lava rock.

3) Remove burner. See diagram below.

4) Remove and discard the 3 pressure regu-

lator mounting screws (A), pressure reg-
ulator tower (B) and diaphragm (C).

5) Insure that the rubber gasket (D) is prop-

erly positioned and install the new HI/LO
pressure regulator assembly  to the valve
using the new screws (E) supplied with
the kit. Tighten screws securely.

6) Pull off the pilot cap to expose the pilot

orifice.

7) Unscrew the pilot  orifice with the allen key

and replace with the LP pilot orifice in the kit.

8) Remove burner orifice with a 1/2" wrench

and discard. Use a wrench to hold on to the
elbow behind the orifice.

9) Reinstall new burner orifice LP stamped

#50 and tighten.

10) Reverse steps 3) to 2).

11) Attach the Conversion label  "This unit has

been converted to Propane" on top of the
Serial # decal.

12) Replace yellow "Natural Gas" label with

red "Propane" label

13) Check for gas leaks.

14) Check inlet and outlet pressures.

15) Check operation of flame control.

16) Check for proper flame appearance and

glow on logs.