Regency E33-NG ユーザーズマニュアル

E33 FPI Direct Vent Gas Insert

This appliance is designed to be attached to 
two 3" (76mm) co-linear aluminium fl ex running 
the full length of the chimney. The fl ue length 
must be a minimum length of 8 '  (2.44m) and 
a maximum of 35' (10.7m). See chart  above 
for minimum distances from roof. Periodically 
check that the vent is unrestricted.

Masonry chimneys may take various contours 
which the fl exible liner will accommodate. 
However, keep the fl exible liner as straight 
as possible, avoid unnecessary bending.

948-305 

3" Flex - 35 ft.

946-529 

FPI Co-linear DV Vertical 

 Termination 

Cap

Alternate Approved Caps
980 Vertical 

Termination 

Cap

991 High 

Wind 

Cap

923GK 3" 

Co-linear 

Adaptor 

with 

 fl 

ashing

1)  If the appliance is to be installed into an 

existing chimney system, thoroughly clean 
the masonry or factory built fi replace.

2)  The appliance is provided with an opening 

on the left hand side of the control compart-
ment. A 3/8" NPT gas supply pipe must be 
brought near this inlet hole. 

In areas of consistently high winds, we recom-
mend using the Simpson Dura-Vent System 
(923GK adapter and 991 high-wind cap).

The Air Intake pipe must be attached to the inlet 
air collar of the termination cap.

3)  Locate the center point where the vent will 

pass through the chimney above the ap-
pliance. Move the appliance into the exact 
location where it is to be installed.  Ensure 
that the Insert is level.

1)  Cut the fl ex liner as required.
 
2)  Mark the end of one liner to indicate 

3)  Connect the other end of the above liner to 

the exhaust side of the termination adap-
tor, seal connection with high temperature 
silicone. Secure with gear clamp.

4)  Connect the 2nd liner to the inlet side of the 

adaptor, seal connection with high tempera-
ture silicone. Secure with gear clamp.

5) Install 

fl 

ashing.

6)  Insert both liners into chimney, passing 

through the damper opening.

7) Install 

termination 

cap.

8) Connect 

the 

marked end of the liner to the 

exhaust  collar of the vent connector plate 
marked with an "E", seal connection with 
high temperature silicone. Secure with gear 
clamp.

9)  Connect the 2nd liner to the intake collar, seal 

connection with high temperature silicone. 
Secure with gear clamp.

NOTE:  
1)  Final gas connection should be made after 

unit is in place to avoid damage to line when 
pushing the unit into position.

2)  Mill-pac may be used instead of high 

tempture silicone and screws may be used 
instead of gear clamps at connections of 
liner to inlet and vent collars.

10) Align vent connector plate with guides on 

unit.  

11)  Slide unit into masonry opening, while ensur-

ing that the slot at the rear of the connector 
plate mates up with the hold down plate on 
the unit.

12) Secure with Screw.