Breckwell P2700 ユーザーズマニュアル

VERTICALLY WITH NEW CHIMNEY SYSTEM 

        (Refer to Figure 7) 
 
NOTE: Follow L-Vent chimney manufacturer’s instructions. 
 
OPTION:  To achieve a center vertical installation a 45º elbow and a 
clean-out tee can be used to offset the pipe from the exhaust outlet 
to the rear center of the stove. 
 
OPTION: Install L-Vent elbow in place of clean-out tee. Locate 
stove. Drop plumb bob to center of tee outlet, mark point on ceiling. 
Install ceiling support and L-Vent pipe per L-Vent manufacturer’s 
instructions. 
 
1. 

Always maintain 3” clearance from combustible materials. 
When passing through additional floors or ceilings, always 
install firestop spacer. 

 
2. 

After lining up for hole in roof, cut either around or square hole 
in roof, always 3” larger all the way around pipe. Install upper 
edge and sides of flashing under roofing materials, nail to the 
roof along upper edge. Do not nail lower edge. Seal nail heads 
with non-hardening waterproof mastic. 

 
3. 

Apply non-hardening, waterproof mastic where the storm collar 
will meet the vent and flashing. Slide storm collar down until it 
sits on the flashing. Seal and install cap. Mobile home 
installations must use a spark arrester. 

 
Adapters are available to adapt from 3” L-Vent to 6” or 8” Class-A 
chimney. (Figure 8a) 
 
As an alternative, 3” or 4” L-Vent can be run inside existing chimney 
to termination. (Figure 8b) 
This is the preferred method. 
 
Follow guidelines for equivalent vent length. 
 
D. 

 
NOTE: Follow L-Vent chimney manufacturer’s instructions. 
 
1. 

Have the masonry chimney inspected by a qualified chimney 
sweep or installer to determine its structural condition. 

 
2. 

You will need a pipe length equal to the chimney height from 
the hearth. If outside combustion air is to be used, you will 
need a pipe length equal to the chimney height plus 18 inches. 

 
3. 

Install a blanking plate and the chimney pipe, and if used the 
outside air pipe, as shown in Figure 9. 
 

4. 

Attach the L-vent adapter, a section of pipe and clean out tee, 
making sure the clean out tee is centered in the chimney flue 
area. Use RTV, metallic tape, and a minimum of three self-
taping screws at all joint connections to ensure a tight seal. 
 

5. 

Position the stove, adhering to the clearances in Figures 1 & 2. 

 
6. 

Measure and build chimney top plate. Cut out holes for 
chimney pipe, and if used the outside air pipe. Install and seal 
with non-hardening mastic to prevent water leakage. Install 
vent cap.