ONKYO T-4555P ユーザーズマニュアル
10
Getting to Know the T-4555P
—Continued
■
C-HDXM tuner board installed
■
C-AMFM tuner board installed
For detailed information, refer to the pages in parentheses.
A
XM ANTENNA (C-HDXM tuner board only)
(21)
(21)
This jack is for connecting the XM Mini-Tuner (not
supplied).
supplied).
B
FM 75
Ω
ANTENNA (14)
This jack is for connecting an indoor or outdoor FM
antenna. An indoor FM antenna is supplied with
each tuner board.
antenna. An indoor FM antenna is supplied with
each tuner board.
C
AM ANTENNA (14)
These push terminals are for connecting an AM
loop antenna or outdoor AM antenna. An AM loop
antenna is supplied with each tuner board.
loop antenna or outdoor AM antenna. An AM loop
antenna is supplied with each tuner board.
D
AUDIO OUTPUT (16)
Using the supplied audio cable, connect these out-
put jacks to an analog audio input on your amp.
put jacks to an analog audio input on your amp.
E
REMOTE CONTROL (17)
These two identical
(Remote Interactive) jacks
can be connected to the
jacks on your other
Onkyo components for interactive control. To use
, the T-4555P must be connected with an
cable and an audio cable.
F
12V TRIGGER IN/OUT (17)
The 12V TRIGGER IN jack can be connected to the
12-volt trigger output on another component, so that
when the other component is turned on, the
T-4555P turns on as well.
12-volt trigger output on another component, so that
when the other component is turned on, the
T-4555P turns on as well.
The 12V TRIGGER OUT jack can be connected to
the 12-volt trigger input on another component, so
that when the T-4555P is turned on, the other com-
ponent turns on as well.
the 12-volt trigger input on another component, so
that when the T-4555P is turned on, the other com-
ponent turns on as well.
G
IR IN/OUT (18)
A commercially available IR receiver can be con-
nected to the IR IN jack, allowing you to control the
T-4555P while you’re in another room, or control it
when it’s out of sight, for example, installed in a
cabinet.
A commercially available IR emitter can be con-
nected to the IR OUT jack to pass IR (infrared)
remote control signals through to other components.
nected to the IR IN jack, allowing you to control the
T-4555P while you’re in another room, or control it
when it’s out of sight, for example, installed in a
cabinet.
A commercially available IR emitter can be con-
nected to the IR OUT jack to pass IR (infrared)
remote control signals through to other components.
H
RS232
This port is for connecting the T-4555P to home
automation equipment and external controllers.
automation equipment and external controllers.
I
Power cord (6)
The power cord should be connected to a suitable
wall outlet.
wall outlet.
Rear Panel
9
1
2
3
4 5 6 7
8
9
4 5 6 7
8
2
3
See pages 16–18 for connection information.
T-4555P_En.book Page 10 Wednesday, August 9, 2006 3:42 PM