Chauvet LX5 ユーザーズマニュアル
General Troubleshooting
Applies to
Symptom
Solution(s)
Lights
Foggers
& Snow
Controllers
Dimmers
& Chaser
Auto shut off
Check fan thermal switch reset
9
Beam is very dim or
not bright
not bright
Clean optical system or replace lamp
Check 220/110v switch for proper setting
Check 220/110v switch for proper setting
9
Breaker/Fuse keeps
blowing
blowing
Check total load placed on device
9
Chase is too slow
Check users manual for speed adjustment
9
9
9
Device has no power
Check for power on Mains.
Check device’s fuse. (internal and/or external)
Check device’s fuse. (internal and/or external)
9
9
9
Fixture is on but
there is no
movement to the
audio
there is no
movement to the
audio
Make sure you have the correct audio mode on the
control switches. If audio provided via ¼” jack, make
sure a live audio signal exists
Adjust sound sensitivity knob
control switches. If audio provided via ¼” jack, make
sure a live audio signal exists
Adjust sound sensitivity knob
9
9
9
Lamps cuts off
sporadically
sporadically
Possible bad lamp or fixture is overheating.
Lamp may be at end of its life.
Lamp may be at end of its life.
9
Light will not come
on after power failure
on after power failure
Some discharge lamps require a cooling off period
before the electronics in the fixture can kick start it
again, wait 5 to 10 minutes before powering up
before the electronics in the fixture can kick start it
again, wait 5 to 10 minutes before powering up
9
Moves slow
Check 220/110v switch for proper setting
9
No flash
Re-install bulb, may have shifted in shipping
9
No light output
Check slip ring & brushes for contact
Install bulb
Call service technician
Install bulb
Call service technician
9
Relay will not work
Check reset switch
Check cable connections
Check cable connections
9
Remote does not
work
work
Make sure connector is firmly connected to device
9
9
Stand alone mode
All Chauvet lighting fixtures featuring stand-alone
functions do not require additional settings, simply
power the fixture and it will automatically enter into this
mode
functions do not require additional settings, simply
power the fixture and it will automatically enter into this
mode
9
*Note not all values apply to all fixtures
If you still have a problem after trying the above solutions, please contact CHAUVET Technical
Support at the location below.
Support at the location below.
Technical Support
Address: Service Dept.
3000 N 29th Ct, Hollywood, FL 33020 (U.S.A.)
Support (Email): tech@chauvetlighting.com
Telephone: (954) 929-1115 - (Press 4)
Fax: (954) 929-5560 - (Attention: Service)
Website: http://www.chauvetlighting.com
3000 N 29th Ct, Hollywood, FL 33020 (U.S.A.)
Support (Email): tech@chauvetlighting.com
Telephone: (954) 929-1115 - (Press 4)
Fax: (954) 929-5560 - (Attention: Service)
Website: http://www.chauvetlighting.com
LX5 8
9/17/2007 12:27 PM