LST IBSST-DR-P01 プリント

© LABOR STRAUSS SICHERUNGSANLAGENBAU GMBH • A-1231 WIEN • WIEGELESTRASSE 36 • TEL +43 1 52114-0 • FAX +43 1 52114-27
OFFICE@LST.AT • WWW.LST.AT • ALL RIGHTS RESERVED

IBSST-DR-P0x_DBL_LST_EN_0804.PDF • PAGE 1

A

Building Safety. Building Security.

Operating voltage 

Supply through loop voltage

Sound level (detector installed) 

typ. 70dB(A) at 1m distance (low)

 

typ. 79dB(A) at 1m distance (medium)

 

typ. 87dB(A) at 1m distance (high)

 

max. 95dB(A) at 1m distance (high)

Flash frequency 

1Hz

Ambient temperature 

-25°C to +70°C

Dimensions ø × H 

112 × 42 (mm) (without detector, incl. base LPBW)

Weight 

136g

Colour 

red / cream, RAL 9001

The loop powered sounder with strobe is fi tted into a 

round, red plastic case. It is powered and actuated as 

a module via the ADM loop with System Sensor/200 

protocol. Fire Detectors Series 200 can be fi tted into 

the integrated base.

The sounder can be activated by a Fire Detection Con-

trol Panel Series BC216 with two different tone types, 

depending on the parameter setup. One of 32 different 

tone  type  combinations  can  be  selected  with  a  DIL-

switch. The following tones are available, for example:

  • Continuous tone 660Hz,

  • Emergency signal according to DIN 33404,

  • Slow whoop tone according to NEN 2575,

  • Alternating tone 800/970Hz, and many more.

The sound level can be selected in 3 steps. The stro-

be is always activated together with the sounder. The 

address  of  the  sounder/strobe  is  selected  with  two 

decadic rotary switches located at the bottom of the 

device.

The  device  is  designed  for  indoor  surface  mounting. 

For this purpose a special base is needed. Two diffe-

rent  base  types  for  protection  classes  IP24  or  IP44 

are available, depending on the application. An optional 

mounting  plate  can  be  supplied  for  surface  mounted 

cabling.

The sounder/strobe is available in two different versi-

ons: With or without integrated dual-isolator module.