American Standard 7272.821 ユーザーズマニュアル
INSTALL DECK MOUNT LABORATORY FITTINGS
INSTALL WALL MOUNT LABORATORY FITTINGS
MAKE WATER SUPPLY CONNECTIONS
1
2
MAKE WATER SUPPLY CONNECTIONS
2
M 9 6 8 4 8 8
Drill two 1-1/8" dia. holes in mounting surface if required
per rough-in dimensions.
per rough-in dimensions.
Assemble rubber washers onto fitting shanks.
Insert fitting shanks through holes of mounting surface.
Assemble steel washers and lock nuts onto fitting shanks.
Align fitting and tighten lock nuts securely with wrench.
Align fitting and tighten lock nuts securely with wrench.
TOOLS AND SUPPLIES REQUIRED
Adjustable Wrench
Teflon Tape
Drill
Plumbers' Putty or
Caulking
Caulking
Channel Locks
Use appropriate
wall escutcheon onto
union swivels
with
adjustable wrench until
adjustable wrench until
are flush against
finished wall.
Note: Center to center dimension of swivel nuts are 8" [203mm].
Connect water supplies to faucet with
3/8" O.D. bull-nose
risers
or 1/2" IPS flexible supplies. Use adjustable wrench
kink copper supply when bending. Use tubing cutter to cut to
proper length.
proper length.
1
NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS
MUST BE PURCHASED SEPARATELY.
MUST BE PURCHASED SEPARATELY.
IMPORTANT: FLUSH ALL SUPPLY LINES PRIOR TO
FITTING INSTALLATION.
FITTING INSTALLATION.
FITTING
FITTING
FLANGE
FITTING
SHANK
Turn off hot and cold water supplies before beginning.
CAUTION
Turn off hot and cold water supplies before beginning.
CAUTION
COUPLING NUT
SUPPLIED WITH
FITTING
STEEL
WASHER
RUBBER
WASHER
WASHER
LOCK NUT
3/8" O.D. BULL-NOSE RISER
OR 1/2" IPS FLEXIBLE SUPPLIES
After installation is complete turn service on and check all
connections for leaks.
connections for leaks.
WALL
ESCUTCHEON
UNION
SWIVELS
SWIVELS
8"
[203mm]
UNION
SWIVEL
SWIVEL
SWIVEL
NUT
NUT
FITTING INLET
SWIVEL
SEAL WASHER
Complete installation, turn on water and check for leaks.
Align
to swivel nuts, if swivel nuts don't align with
Insert
into swivel nuts if not already installed. Tighten
both swivel nuts to make water tight connections.
COLD
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR
WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH,
ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A
COARSE SURFACE.
for installation and must be ordered separate
MTG. SHANK KIT
RDERED SEPARATELY)
M962325-0070A
IMPORTANT: FLUSH ALL SUPPLY LINES PRIOR TO
FITTING INSTALLATION.
FITTING INSTALLATION.