ONKYO 29344937 ユーザーズマニュアル

50

This section explains functions that can be used with any 
input source.

You can adjust the bass and treble for the front speakers, 
except when the Direct, Pure Audio listening mode is 
selected.

■ Bass
You can boost or cut low-frequency sounds output by the 
front speakers from –10 dB to +10 dB in 2 dB steps.

■ Treble
You can boost or cut high-frequency sounds output by 
the front speakers from –10 dB to +10 dB in 2 dB steps.

You can display various information about the current 
input source as follows.

Note:
This procedure can also be performed on the AV receiver 
by using its [DISPLAY] button.

The following information can typically be displayed:

*1 When AM or FM radio is used, the band, preset number, and 

frequency are displayed. 

*2 If the input signal is analog, or AM or FM radio is selected, no 

format information is displayed. If the input signal is PCM, the 
sampling frequency is displayed. If the input signal is digital but 
not PCM, the signal format is displayed. Information is 
displayed for about 3 seconds, then the previous display 
reappears. 

Tip:
This procedure can also be performed 
on the remote controller by using 
[AUDIO] button (see page 73).