ONKYO 29344934 ユーザーズマニュアル

ページ / 92
4
Speaker Precautions
Placement
• The subwoofer cabinet is made out of wood and is 
therefore sensitive to extreme temperatures and 
humidity, do not put it in locations subject to direct 
sunlight or in humid places, such as near an air condi-
tioner, humidifier, bathroom, or kitchen.
• Do not put water or other liquids close to the speakers. 
If liquid is spilled over the speakers, the drive units 
may be damaged.
• Speakers should only be placed on sturdy, flat surfaces 
that are free from vibration. Putting them on uneven or 
unstable surfaces, where they may fall and cause dam-
age, will affect the sound quality.
• Subwoofer is designed to be used in the upright verti-
cal position only. Do not use it in the horizontal or 
tilted position.
• If the unit is used near a turntable, CD player or DVD 
player, howling or slipping of sound may occur. To 
prevent this, move the unit away from the turntable, 
CD player or DVD player, otherwise lower the unit’s 
output level.
Using Close to a TV or Computer
TVs and computer monitors are magnetically sensitive 
devices and as such are likely to suffer discoloration or 
picture distortion when conventional speakers are placed 
nearby. To prevent this, the SKF-570 and SKC-570 
feature internal magnetic shielding. In some situations, 
however, discoloration may still be an issue, in which case 
you should turn off your TV or monitor, wait 15 to 30 
minutes, and then turn it back on again. This normally 
activates the degaussing function, which neutralizes the 
magnetic field, thereby removing any discoloration 
effects. If discoloration problems persist, try moving the 
speakers away from your TV or monitor. Note that 
discoloration can also be caused by a magnet or 
demagnetizing tool that’s too close to your TV or monitor. 
Do not place SKR-570 and SKB-570 close to TV or a 
computer monitor because they have no magnetic shield.
Input Signal Warning
The speakers can handle the specified input power when 
used for normal music reproduction. If any of the 
following signals are fed to them, even if the input power 
is within the specified rating, excessive current may flow 
in the speaker coils, causing burning or wire breakage:
1. Interstation noise from an untuned FM radio.
2. Sound from fast-forwarding a cassette tape.
3. High-pitched sounds generated by an oscillator, 
electronic musical instrument, and so on.
4. Amplifier oscillation.
5. Special test tones from audio test CDs and so on.
6. Thumps and clicks caused by connecting or discon-
necting audio cables (Always turn off your ampli-
fier before connecting or disconnecting cables.)
7. Microphone feedback.
Package Contents
Make sure you have the following accessories:
*
In catalogs and on packaging, the letter at the end of the product 
name indicates the color. Specifications and operation are the 
same regardless of color. 
AV receiver HT-R570
HT-R570
Remote controller and two batteries (AA/R6)
Speaker setup microphone
Indoor FM antenna
AM loop antenna
HT-S5200_En.book  4 ページ  2009年3月9日 月曜日 午後4時31分