ONKYO 29344934 ユーザーズマニュアル
77
Audyssey Dynamic Volume™
Dyn Vol
See “Dyn Vol” of “Audio Adjust Settings” on page 74.
Music Optimizer
The Music Optimizer function enhances the sound quality of compressed music files. Use it with music files that
use “lossy” compression, such as MP3.
The Music Optimizer function enhances the sound quality of compressed music files. Use it with music files that
use “lossy” compression, such as MP3.
Note:
The Music Optimizer function only works with PCM digital audio input signals with a sampling rate below 48kHz
and analog audio input signals. The Music Optimizer is disabled when the Direct listening mode is selected.
The Music Optimizer function only works with PCM digital audio input signals with a sampling rate below 48kHz
and analog audio input signals. The Music Optimizer is disabled when the Direct listening mode is selected.
M.Optimizer
Off: Music Optimizer off (default).
On: Music Optimizer on.
Speaker Levels
You can adjust the volume of each speaker while listening to an input source.
These temporary adjustments are cancelled when the AV receiver is set to Standby.
You can adjust the volume of each speaker while listening to an input source.
These temporary adjustments are cancelled when the AV receiver is set to Standby.
Notes:
• You cannot use this function while the AV receiver is muted.
• Speakers that are set to “No” or “None” in the “3. Sp Config” cannot be adjusted (see page 70).
• You cannot use this function while the AV receiver is muted.
• Speakers that are set to “No” or “None” in the “3. Sp Config” cannot be adjusted (see page 70).
SW Level (Subwoofer)
–15dB to +12dB (default: 0dB)
C Level (Center)
–12dB to +12dB (default: 0dB)
A/V Sync
When using progressive scanning on your DVD player, you may find that the picture and sound are out of sync.
With this setting, you can correct this by delaying the audio signals.
When using progressive scanning on your DVD player, you may find that the picture and sound are out of sync.
With this setting, you can correct this by delaying the audio signals.
Notes:
• This setting is not available when the Direct listening mode is used with an analog input signal.
• The setting is stored individually for each input selector.
• This setting is not available when the Direct listening mode is used with an analog input signal.
• The setting is stored individually for each input selector.
A/V Sync
0ms to 100ms in 20ms steps
HT-S5200_En.book 77 ページ ２００９年３月９日 月曜日 午後４時３１分