ONKYO SKF-540F ユーザーズマニュアル

 

13

 

• If the remote controller doesn’t work reliably, try 

replacing the batteries.

• Don’t mix new and old batteries or different types of 

batteries.

• If you intend not to use the remote controller for a long 

time, remove the batteries to prevent damage from 
leakage or corrosion.

• Expired batteries should be removed as soon as possi-

ble to prevent damage from leakage or corrosion.

When using the remote controller, point it toward the AV 
receiver’s remote control sensor, as shown below.

 

• The remote controller may not work reliably if the AV 

receiver is subjected to bright light, such as direct sun-
light or inverter-type fluorescent lights. Keep this in 
mind when installing.

• If another remote controller of the same type is used in 

the same room, or the AV receiver is installed close to 
equipment that uses infrared rays, the remote control-
ler may not work reliably.

• Don’t put anything on top of the remote controller, 

such as a book or magazine, because a button may be 
pressed continuously, thereby draining the batteries.

• The remote controller may not work reliably if the AV 

receiver is installed in a rack behind colored glass 
doors. Keep this in mind when installing.

• The remote controller will not work if there’s an obsta-

cle between it and the AV receiver’s remote control 
sensor.

Approx. 16 ft. 
(5 m)

Remote control sensor

STANDBY indicator

AV receiver

HT-S790_En.book Page 13 Friday, February 17, 2006 3:28 PM