Mitsubishi Electronics 838 SERIES ユーザーズマニュアル

Press one of the upper buttons on the remote 
control to change to the correct mode for the 
product you want to control.  Refer to the table 
below.  Only one of each device type can be con-
trolled in each mode.

Cable Box
DTV Receiver
Satellite Receiver

VCR

DVR
DVD Player/Recorder

DVD Player/Recorder
DVR

VCR

A/V Receiver
Audio Amplifier

CD Player

Press and hold 

POWER on the remote control for 

several seconds until the key flashes twice and 
goes off.

Release the 

POWER key.

Enter the first five-digit code listed for your equip-
ment in the reference tables that follow.
If you need to start over or wish to exit 
programming mode, temporarily change to a 
different device mode.

Point the remote control at the equipment and 
press 

POWER.  If the product has no power on/off 

function, press a different key, such as 

  (STOP), VOLUME UP, or MUTE.

•  If the equipment responds, the remote control 

is properly programmed.

•  If the equipment does not respond, repeat 

steps 4 and 5 with the next five-digit code 
listed for your equipment.

Once you have found the correct code, write it in 
the space below for future reference.

To determine the code programmed for any mode:

Set the mode to the one you wish to verify.

Press and hold 

POWER on the remote control for 

several seconds until the key flashes twice and goes 
off.

Press keys 

Press 

1 and count the flashes of the power key.  

Write down the number of flashes as the first digit 
of the code.

Repeat step 4 for the other digits of the code.  
Press 

2 to see flashes for the second digit, press 3 

for the third digit, 

4 for the fourth digit, and 5 for the 

fifth digit.

With Audio Lock enabled, the remote control oper-
ates volume and mute on an A/V receiver in all control 
modes.  Activate Audio Lock if you always use an A/V 
receiver with your TV and other A/V equipment.

Program 

AUDIO mode for your A/V receiver as 

described in “Programming the Remote Control” on 
this page.

With the remote control in 

AUDIO mode, hold POWER 

on the remote control for several seconds until the 
key flashes twice and goes off.

Press keys 

The 

POWER key will flash twice to indicate Audio 

Lock is active.

Press and hold 

POWER for several seconds until it 

flashes twice and goes off.

Press keys 

9   9   3   VOLUME UP.

The 

POWER key will flash four times to indicate Audio 

Lock has cleared.