Runco Home Theater Projection System ユーザーズマニュアル
LightStyle™ LS-12HBd Installation/Operation Manual
83
PRE
L
IMINAR
Y
Input Names: You can give each input a descriptive name. For example, you may want
to change the default input name to the type of source component connected to it:
“VCR,” “DVD,” “Laptop” et cetera. Input names can be up to 12 characters long.
to change the default input name to the type of source component connected to it:
“VCR,” “DVD,” “Laptop” et cetera. Input names can be up to 12 characters long.
To edit an input name, select Input Names from the Service menu. Press
or
to select
an input and press ENTER. Use the
or
buttons to change a character; press
or
to select a character to change. When you have finished editing the input name,
press ENTER or MENU.
To restore the default input name, press
repeatedly to highlight that input name in the
“Restore” column. Then, press ENTER.
infrared (IR) custom code (address) that the Dimension Digital Controller will accept as
valid IR data. By default, it is set to 08209 (0x2011). You can change this setting if:
valid IR data. By default, it is set to 08209 (0x2011). You can change this setting if:
• Another device in the theater (a DVD player, for example) is responding to
commands from the Dimension Digital Controller remote control (Figure 2-7) in ways
that are unpredictable or undesirable; or
that are unpredictable or undesirable; or
• You have multiple Dimension Digital Controllers and want to control them
independently, as opposed to broadcasting commands from a single remote to all of
them. In this scenario, you can use multiple remotes programmed to use different IR
codes. Or, you can use a single remote and change the IR code as needed to
address a specific Dimension Digital Controller.
them. In this scenario, you can use multiple remotes programmed to use different IR
codes. Or, you can use a single remote and change the IR code as needed to
address a specific Dimension Digital Controller.
After changing the Remote Code, press EXIT to have the new code take effect.
Input Names
Restore
C o mp o s i t e
1
C o mp o s i t e
2
C o mp o s i t e
3
C o mp o n e n t
Component
H D
1
HD 1
H D
2
HD 2
S C A R T
SCART
H D M I
1
HDMI 1
H D M I
2
HDMI 2
H D M I
3
HDMI 3
H D M I
4
HDMI 4
H D M I
5
HDMI 5
H D M I
6
HDMI 6
H D M I
7
HDMI 7
H D M I
8
HDMI 8
D i s p l a y P o r t
DisplayPort
Use the Dimension Digital Controller front-panel keypad to change
the IR code to which the controller will respond. Then, change the
code sent by the remote to match as described below.
the IR code to which the controller will respond. Then, change the
code sent by the remote to match as described below.
Tip