Runco SC-60D ユーザーズマニュアル
Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual
49
PRE
L
IMINAR
Y
Yaw Adjust: Loosen the Yaw/X-Adjustment Levers to allow the lens to pivot freely from
side to side. Then, angle the lens to even out any left-to-right pincushion distortion:
side to side. Then, angle the lens to even out any left-to-right pincushion distortion:
Once the proper lens angle has been set, firmly tighten the Yaw/X-Adjustment Levers to
secure the lens in place.
secure the lens in place.
Geometry:
1.
Input an anamorphic cross-hatch test pattern to the DHD Controller.
2.
Unscrew the Anamorphic Lens just enough to allow it to rotate freely.
3.
Grasp the lens by the center ring and rotate the lens until the image is properly
anamorphic:
anamorphic:
4.
When the image geometry appears correct, tighten the
Anamorphic Lens Set Screw (item #10) to secure the lens in place.
(When viewed from the front, the rear opening on the anamorphic
lens should appear as a tall, narrow oval.)
Anamorphic Lens Set Screw (item #10) to secure the lens in place.
(When viewed from the front, the rear opening on the anamorphic
lens should appear as a tall, narrow oval.)
Anamorphic Lens (Top View)
Wrong Position
Correct Position
Wrong Position
Correct Position