Sharp BD-MPC41U ユーザーズマニュアル
34
Loading the Batteries in the
Remote Control
Press down on the tab in the direction of the
arrow to remove the battery cover.
arrow to remove the battery cover.
Load the two “AAA” size batteries (R-03 size,
UM/SUM-4) supplied with the remote control.
Make sure that the battery poles
UM/SUM-4) supplied with the remote control.
Make sure that the battery poles
m
and
n
are
positioned as indicated.
Slide the battery cover in the direction of the
arrow until it clicks.
arrow until it clicks.
NOTE
Do not subject the remote control to shock, water or
excessive humidity.
The remote control may not function if the system's remote
sensor is in direct sunlight or any other strong light.
Incorrect use of batteries may cause them to leak or burst.
Read the battery warnings and use the batteries properly.
Do not mix old and new batteries, or mix different brands.
Remove the batteries if you will not use the remote control
for an extended period of time.
excessive humidity.
The remote control may not function if the system's remote
sensor is in direct sunlight or any other strong light.
Incorrect use of batteries may cause them to leak or burst.
Read the battery warnings and use the batteries properly.
Do not mix old and new batteries, or mix different brands.
Remove the batteries if you will not use the remote control
for an extended period of time.
•
•
•
•
•
•
WARNING
Do not use or store batteries in direct sunlight or other
excessively hot place, such as inside a car or near a heater.
This can cause batteries to leak, overheat, explode or
catch fire.
It can also reduce the life or performance of batteries.
excessively hot place, such as inside a car or near a heater.
This can cause batteries to leak, overheat, explode or
catch fire.
It can also reduce the life or performance of batteries.
•
1
2
3
Approximate operating range of
remote control
Remote control sensor
Remote control
30º
30º
approx. 22 feet
(7 m)
(7 m)
Connecting the Power Cord
Plug the supplied AC cord into the AC IN terminal on
the rear of this system. Then plug into an AC outlet
with ground hole.
the rear of this system. Then plug into an AC outlet
with ground hole.
To AC outlet with ground hole
AC power cord
To AC IN terminal
NOTE
Place the system close to the AC outlet, and keep the
power plug within reach.
TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT
TOUCH THE UN-INSULATED PARTS OF ANY CABLES
WHILE THE AC CORD IS CONNECTED.
The STANDBY indicator blinks while the system is
preparing for starting up. You cannot turn the system on
until the STANDBY indicator stops blinking.
If you are not going to use this system for a long period of
time, be sure to remove the AC cord from the AC outlet.
power plug within reach.
TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT
TOUCH THE UN-INSULATED PARTS OF ANY CABLES
WHILE THE AC CORD IS CONNECTED.
The STANDBY indicator blinks while the system is
preparing for starting up. You cannot turn the system on
until the STANDBY indicator stops blinking.
If you are not going to use this system for a long period of
time, be sure to remove the AC cord from the AC outlet.
•
•
•
•
Before Starting Playback
BD-MPC41U_E.indb 34
BD-MPC41U_E.indb 34
2010/02/04 16:14:37
2010/02/04 16:14:37