Sim2 Multimedia HT500 LINK ユーザーズマニュアル

3

Prior to switching on the projector please read each chapter of 

this manual carefully as this manual provides basic instructions 

for using the projector.

The installation of the lamp assembly, preliminary adjustments 

and procedures that necessitate the removal of the top cover, 

must be carried out by authorised, trained technicians. There are 

no user serviceable parts inside. To ensure safe and long term 

reliability please use power cables supplied with the projector. 

Observe all warnings and cautions.

ATTENTION:

To reduce the risk of electric shock, disconnect 

the power supply cable on the rear panel before 

removing the top cover of the projector. 

Refer to trained, authorised personnel for tech-

nical assistance.

• Federal Communication Commission (FCC Statement)

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These 

limits are designed to provide reasonable protection against harmful interference when the equipment is used in a commercial environment. This 

equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may 

cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. 

If this equipment does cause harmful interference to radio or television reception, which can be determinated by turning the equipment off and 

on, the user is encuraged to try to correct the interference by one or more of the following measures:

-   Reorient or relocate the receiving antenna

-  Increase the separation between the equipment and receiver.

-   Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

-  Consult the dealer or an experienced radio/TV technician for help. 

• For customers in Canada

This Class B digital apparatus complies with Canadian ICES-003.

•  For customers in the United Kingdom

ATTENTION: This apparatus must be earthed

The wires in this mains lead are coloured in accordance with the following code:

 

Green-and-Yellow:  Earth

 

Blue: 

 

 

Neutral

 

Brown:   

 

Live

As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your 

plug proceed as follows:

The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked by the letter E or by the safety earth 
symbol   or coloured green or green-and-yellow.

The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.

The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.

This  symbol  indicates  the  possible  electric  shock 
hazard associated with uninsulated live components 
in the interior of the unit.

This  symbol  indicates  the  presence  of  important 
instructions regarding use and maintenance of the 
product.

The HT500LINK system consists of two parts connected by a fibre optic cable: the DigiOptic™ Image Processor and the Projector. 
In this manual references to the “unit” refer to one of the two units that make up the system. 

CLASS 1 LASER PRODUCT

This  product  complies  with fda radiation performance standards, 21 cfr chapter 
1 subchapter j.
This product complies with european standard en 60825.
This  product  is  classified  as a class 1 laser product and there is no hazardous 
radiation with the safety protection.
Danger! Invisible  laser radiation when open. avoid direct exposure to beam.
Do  not open the covers of the product and never touch the internal parts in order 
to avoid exposure to visible or invisible laser radiation.