Tascam SN29401376 ユーザーズマニュアル

■

Analog/PCM/Digital
With this setting, you can specify the listening mode 
used when an analog (CD, TV, LD, VHS, MD, turntable, 
radio, cassette, cable, satellite, etc.) or PCM digital (CD, 
DVD, etc.) audio signal is played.

■

Mono/Multiplex Source
With this setting, you can specify the listening mode 
used when a mono digital audio signal is played (DVD, 
etc.).

■

2ch Source
With this setting, you can specify the listening mode 
used when 2-channel (2/0) stereo digital sources, such as 
Dolby Digital or DTS, are played.

■

Dolby D/Dolby D Plus/TrueHD
With this setting, you can specify the listening mode 
used when Dolby Digital or Dolby Digital Plus format 
digital audio signals are played (DVD, etc.). Specifies 
the default listening mode for Dolby TrueHD sources, 
such as Blu-ray or HD DVD (input via HDMI).

■

DTS/DTS-ES/DTS-HD
With this setting, you can specify the listening mode 
used when DTS or DTS-HD High Resolution format 
digital audio signals are played (DVD, LD, CD, etc.). 
Specifies the default listening mode for DTS-HD Master 
Audio sources, such as Blu-ray or HD DVD (input via 
HDMI).

■

Other Multich Source
Specifies the default listening mode for multichannel 
PCM sources from HDMI IN such as DVD-Audio, and 
DSD multichannel sources such as Super Audio CD.

■

`

Off, 30 to 79

With this setting, you can limit the maximum volume.
To disable this setting, select “Off”.

■

`

Last, Min, 1 to 79 or Max

With this setting, you can specify the volume setting to be 
used each time the AV receiver is turned on.
To use the same volume level that was used when the AV 
receiver was turned off, select “Last”.
The “Power On Volume” setting cannot be set higher than 
the “Maximum Volume” setting.

■

`

–12dB to 0dB to +12dB

With this setting, you can specify the headphone volume 
relative to the main volume. This is useful if there’s a 
volume difference between your speakers and your 
headphones.

q/w to select the signal format that you want to 

e/r to select a listening mode.

Only listening modes that can be used with each input 
signal format can be selected (

➔ pages 35 to 39).

The “Last Valid” option means that the listening 
mode selected last will be used.
The “Straight Decode” option means that straight 
decoding listening mode (Dolby Digital, DTS, etc.) is 
selected.

• For  the  “TUNER” input selector, only “Analog” will be 

available.

• For  the  “NET” or “USB” input selector, only “Digital” 

will be available.

“Setup”