JVC TH-S3 TH-S2 ユーザーズマニュアル

Operating external components with the remote control

NOTE

• Manufacturers’ codes are subject to change without notice.
• Set the codes again after replacing the batteries of the remote control.

7 To set the manufacturer’s code

You can operate a JVC TV without setting the manufacturer’s code.

Slide the remote control mode selector
to TV.

Press and hold

TV.

Keep the button pressed until step 4 is finished.

Press ENTER.

Press number buttons (1-9, 0) to enter
the manufacturer’s code (2 digits).

Examples:
For a Hitachi TV:

Press 1, then 0.

For a Toshiba TV:

Press 0, then 8.

Release

TV.

If there is more than one code listed for corresponding brand,
try each one until you enter the correct one.

7 Operation

Aim the remote control at the TV.

IMPORTANT
Before using the remote control to operate a TV;
• Set the remote control mode selector to TV.

The following buttons are available:

TV:Turns TV on and off.

TV VOL +/–:Adjusts the volume.
TV/VIDEO:Selects the input mode (either TV or VIDEO).
CHANNEL +/–:Changes the channels.
1-10, 0, +10 (100+):Selects the channel.
TV RETURN:Alternates between the previously selected channel
and the current channel.

The buttons described below are used on pages 11 and
12.

Operating the TV

Remote control
mode selector

Number
buttons

(play button)

Manufacturer

Code

Manufacturer

Code

JVC

Samsung

Hitachi

Sanyo

Magnavox

Sharp

Mitsubishi

Sony

Panasonic

04, 11

Toshiba

RCA

Zenith

TH-S3[C].book Page 11 Monday, April 12, 2004 11:20 AM