Electrolux Z2250 series ユーザーズマニュアル

ページ / 12
How To Use
 (continued)
NOTE: Do  not  place  the  cleaner 
on  furniture  or  steps  for 
any period of time as the 
brush  roll  may  cause 
damage. Place the cleaner 
on the floor with the handle 
in  the  upright/storage 
position  while  using  the 
accessories. Do not allow 
the cleaner to tilt forward 
or to the side when using 
accessories.  This  will 
prevent  the  unit  leaning 
ans  causing  possible 
damage  to  carpets  or 
floors.
1.  To use accessories remove hose 
from  hose  retainer  on  back  of 
cleaner by lifting up and twisting.
2.  Place desired accessory onto 
end of hose or crevice nozzle.
  Turn ridge end to center.
  Push tubes together.
  Grasp both tubes near ridges.
Dusting/Upholstery  Brush
  is  for  furniture,  blinds, 
books, lamp shades, shelves, curtains, draperies, cushions 
and fabrics.
Crevice Nozzle 
cleans corners, stairs, skirting boards, and 
between cushions.
Nested extension tubes
 to add reach (on some models).
  Pull apart.
Dusting/
Upholstery
Brush
Crevice 
Nozzle
Routine Maintenance
CAUTION: Turn off the switch and unplug the electrical 
cord before routine maintenance. Never operate 
the vacuum cleaner without the dustbag or filter 
assembly in place.
NOTE: Due to the powerful motor fitted to this vacuum, 
you may notice a higher level of noise than that 
of your previous model, and that it will pick up 
considerably more than your old model. You may 
need to change the dust bag more frequently as a 
result of this better pickup. When vacuuming using 
carpet  fresheners  or  cleaners,  powder,  plaster 
dust, or similar fine substances, the dustbag and 
filters will require more frequent maintenance.
The  instructions  in  this  booklet  serve  as  a  guide  to  routine 
maintenance. To avoid unnecessary service calls, check the  
dustbag, filters, belt, and brushroll often.
Removing the Dustbag ES82:
(Alternate bag is E82)
Remove dustbag cover.
Grasp dustbag and pull from 
cleaner.
Shake filter to remove excess dust. If necessary, the 
filters  may  be  cleaned  by  vacuuming  with  another 
cleaner.
Check the 
filters each time the dustbag is changed. 
Clean or replace as needed.
6
remove 
install 
NOTE:  Frequent  cleaning  of 
the  filters  will  maintain 
maximum  efficiency  of 
your  cleaner.  The  foam 
and pleated filters should 
be removed for frequent 
washing and can be used 
in  rotation  with  extra 
filters  (available  through 
Electrolux  Helpline)  to 
ensure  clean,  dry  filters 
are always ready for use.
EF82
HEPA 
Filter
EF1
Motor 
Filter