Zenoah RMSZ2500 ユーザーズマニュアル

ページ / 36
every every every every
25
40
50
100
system/compornent
procedure
before hours hours hours hours
note
use
after
after
after
after
fuel leaks, fuel spillage
wipe out
fuel tank, air filter, fuel filter
inspect/clean
replace, if necessary
see 
■ADJUSTING
replace carburetor
idle adjusting screw
IDLING SPEED (p.19)
if necessary
clean and readjust 
GAP: .025in(0.6~0.7mm)
spark plug
plug gap
replace, if necessary
cylinder fins, 
clean
intake air cooling vent
muffler, spark arrester, 
clean
cylinder exhaust port
throttle lever, ignition switch check operation
replace if 
sweeper unit
something's wrong
gear case
oil
screws/nuts/bolts
tighten/replace
✔ not adjusting screws
23 
9. Maintenance
ENGINE
SHAFT
■ MAINTENANCE CHART
■ GEARCASE LUBRICATION 
With the exception of oil leaks or contamination,
the RedMax Sweeper's oil filled gearcase is
designed to last the life of the machine under
normal use: 
• It is not necessary to add oil or to "top off" the
gearcase under normal operating conditions. 
• For continuous heavy-duty applications, (such
as where the machine will be stopped only
during refueling), RedMax recommends
replacing RedMax Sweeper gearcase oil every
40 hours of operation. 
■ REPLACING THE GEARCASE OIL (MA1)
Warm the gearcase oil by running the RedMax
Sweeper at varying speeds for approximately 8-10
minutes, and then switch the engine to "OFF" and
disconnect the spark plug wire at the engine. Use
the following procedure to remove and replace all
gearcase oil. 
Maintenance, replacement, or repair of the emission control device and systems may be
performed by any non-road engine repair establishment or individual.