Electrolux S107 ユーザーズマニュアル

ページ / 8
Cleaning and Replacing Dust Cup Filter, PN 62406
Pull fi lter off of fi lter frame.
Shake and brush the dust and dirt from fi lter.  If desired, launder fi lter by 
by 
hand in warm water using a mild detergent.
NOTE:  Air dry thoroughly before returning to use.
To put fi lter on fi lter frame, pull and stretch the elastic edge of fi lter up and 
over the rim on the fi lter frame.
How To Maintain
The instructions in this booklet serve as a guide to routine maintenance. To keep the cleaner operating at top effi ciency empty 
the dust cup and clean the fi lter after each use.
Empty Dust Cup
CAUTION:  Turn off the switch and unplug the electrical cord before servicing.
1.   Remove hand vac from the base unit. 2.   Push in on dust cup latch 
and  pull  dust  cup  from 
handle section.
3.   Remove dust cup fi lter from dust 
cup. Shake and brush the dust and 
dirt from fi lter.
Dust 
Cup 
Latch
4.   Shake  contents  of  dust  cup  into  a 
waste container.
5.   Replace  dry dust  cup  filter  in  dust 
cup and reassemble following above 
directions in reverse.
NOTE:  Replace a dirty or torn fi lter.
6.   Dust cup may be cleaned with warm 
water and mild detergent. Wipe dry, do 
not put dust cup in dishwasher.
Clean Brush Roll
The brush roll turns to sweep and comb the carpet nap. Keep the brush 
roll free from hair and threads so it will continue cleaning.
Elastic 
Edge
Filter 
Frame
Rim
Correct Installation
Correct Installation
NOTE:  If fi lter is not properly installed, dirt and dust will go past the 
fi lter and this can damage the cleaner motor.
6