Electrolux S670 ユーザーズマニュアル

HOW TO ASSEMBLE

CAUTION: Completely assemble vacuum cleaner before

using.

Assembly Packet is with ownerʼs guide.

2-Part

Bolt

Lower

Cord Hook

Bag

Screws

Step 1

Attach the Handle

Push lower handle into handle socket on the base.
NOTE: Check to be sure slot in handle is positioned

correctly, see Detail A.

Align the holes on the lower handle and the socket. Insert

a 2-part bolt (A) in the bottom center of the handle and

tighten.
Push upper handle onto lower handle. Make sure grip curves

away from cleaner. Align the holes on the upper handle

to the holes on the lower handle. Insert a 2-part bolt (A)

in center of the handle and tighten.

001 ASSEMBLED

Step 2

Attach Lower Cord Hook

Make sure cord hook is pointing downwards. Press the power

cord into the groove on the cord hook pulling any slack toward

the base of the cleaner. On the cord hook, ﬁ nd the curved

tab and place in slot on lower handle section, keep cord taut

while pressing the cord hook to the left until it snaps into slot

on opposite side of handle. The hook should point downward

on the same side that the cord exits the hood.

Step 3

Attach Outer Bag

IMPORTANT: To provide a good gasket seal, the bag

coupling must seat firmly against the

motor base.

Hold outer bag with zipper away from the handle. Line up

screw holes. Start the bag screws by hand, then tighten with

a screwdriver.
Loop the bag spring onto the bag support hook located at the

back of the upper handle section.

Step 4

Store Electrical Cord

The cleaner has two convenient cord storage hooks attached

to the handle. However, some models feature a quick release

cord hook on the upper handle. A downward twist of the cord

hook frees the cord for quick removal. With either style, wind

the cord around the hooks for storage. Fasten the plug to the

cord to prevent unwinding.