Rinnai R98LSe ユーザーズマニュアル

 

16 

VA Series Outdoor LS Manual 

  Flushing the Heat Exchange (Error Code: LC or 00)

An “LC” or “00” error code indicates the unit is beginning to lime up and must be flushed.  Failure to flush the 
appliance will cause damage to the heat exchanger.  Damage caused by lime buildup is not covered by the unit’s 
warranty.  After flushing, reset the LC fault code by turning off the power to the unit and turning the power back 
on. 

Pressure Relief Valve

3/4" Ball Valve

3/4" Union

Check Valve

S

Pressure Regulator

Circulating Pump

Solenoid Valve

Boiler Drain Valve

Gas Supply

5 gallon pail of virgin, food
grade, white vinegar (or virgin,
food grade, citric acid).

Cold Water Line

Hot Water Line

n-line

Filter

I

1.  Disconnect electrical power to the water heater. 

2.  Close the shutoff valves on both the hot water and cold 

water lines (V3 and V4). 

3.  Connect pump outlet hose (H1) to the cold water line at 

service valve (V2). 

4.  Connect drain hose (H3) to service valve (V1). 

5.  Pour approximately 4 gallons of virgin, food grade, white 

vinegar or citric acid into pail. 

6.  Place the drain hose (H3) and the hose (H2) to the pump 

inlet into the cleaning solution. 

7.  Open both service valves (V1 and V2) on the hot water and 

cold water lines. 

8.  Operate the pump and allow the cleaning solution to 

circulate through the water heater for at least 45 minutes. 

9.  Turn off the pump. 

10.  Rinse the cleaning solution from the water heater as follows:

a. remove the free end of the drain hose (H3) from the pail 

b. close service valve, (V2), and open shutoff valve, (V4).  Do 

not open shutoff valve, (V3). 

c.  allow water to flow through the water heater for 5 minutes 

d. close service valve, (V1), and open shutoff valve, (V3). 

11.  Disconnect all hoses. 

12.  Remove the in-line filter at the cold water inlet and clean out 

any residue.  Place filter back into unit. 

13.  Restore electrical power to the water heater.