Honeywell 1EN2R-9005 0406R3-NE ユーザーズマニュアル

EN2R-9005 0406R3-NE

20

Products are manufactured under an ISO 9001 (1994) based 
and certified Quality System.

The quality system is described in the Honeywell Combustion 
Controls Center Quality Assurance Programme and its related 
operational procedures and instructions.

The quality system is approved by Gastec against certificate 
number 9.302/2.

The quality organisation is responsible for defining, 
maintaining, improving and verification of the quality systems 
in the field of design, production process and field quality 
service.

Assembly processes are guided by work instructions. Patrol 
inspections form part of the assembly processes.

At the end of the assembly phase, all aqustats are leakage 
and performance tested/adjusted.

Assembly inspection is performed by employees of the quality 
control department, using their own equipment.

All inspections (incoming and assembly) are performed by 
trained personel and according inspection procedures.

The L41../L61.. series Aquastats have been designed 
according the Low Voltage Directive 73/23/EEC.

This Low Voltage Directive is covered by approvals in 
Denmark, Finland, Norway, Sweden and Switserland.

EMC Directive 89/336/EEC:
The snap action switch ensures in most cases a switching 
action in less than 10 ms, which satisfies EMC-Directive 
without further measures. 

The exception is a highly inductive low current load combined 
with slow rate of temperature change, which requires 
additional suppression means.

 For this reason compliance 

with the EMC-Directive cannot be claimed.

Europen countries accept above certificates as basis for 
appliance approval.

An additional approval is obtained from DIN in Germany 
according to DIN 3440 as thermostat (TR) or temperature 
limiter (TW).

In North-America approvals have been obtained from UL, 
AGA and CSA.