Denon AVR-4810CI ユーザーズマニュアル

In addition to the AVR-4810CI, the included main remote control unit 
(RC-1126) can also be used to operate the equipment listed below.
q

DENON system components

w

Non-DENON system components
To operate component products other than DENON, you must set 
the preset code (vpage 109 “Presetting”). 
If you are using a non-DENON AV device, or if you cannot operate 
the device even after registering the preset code, memorize the 
other  device’s  remote  control  signal  in  the  AVR-4810CI  remote 
control unit (vpage 113 “Learning Function”). 

•

•

LR6/AA

R03/AAA

(RC-1126)

(RC-1121)

w

  Load the two batteries properly as indicated by the marks in the 

battery compartment.

(RC-1126)

(RC-1121)

e

  Put the rear cover back on.

q

  Lift the clasp and remove the rear lid.

Insert the specified batteries in the remote control unit. 
Replace  the  batteries  with  new  ones  if  the  set  does  not  operate 
even when the remote control unit is operated close to the unit. (The 
supplied batteries are only for verifying operation.)
When inserting the batteries, be sure to do so in the proper direction, 
following the “q” and “w” marks in the battery compartment.
 To prevent damage or leakage of battery fluid:

Do not use a new battery together with an old one.
Do not use two different types of batteries.
Do not attempt to charge dry batteries.
Do not short-circuit, disassemble, heat or dispose of batteries in 

flames.
If the battery fluid should leak, carefully wipe the fluid off the inside 
of the battery compartment and insert new batteries.
Remove the batteries from the remote control unit if it will not be in 
use for long periods.
Used batteries should be disposed of in accordance with the local 
regulations regarding battery disposal.

•
•

•

•

•
•
•
•

•

•

•

30°

30°

Approx. 23 feet / 7 m

or

(RC-1126)

(RC-1121)

The set may function improperly or the remote control unit may not 
operate  if  the  remote  control  sensor  is  exposed  to  direct  sunlight, 
strong artificial light from an inverter type fluorescent lamp or infrared 
light.

t

y

i

Q5

Q2

Q0

Q4

Q1

Q3

q

 Owner’s manual ...................................................................... 1

w

 Getting started ........................................................................ 1

e

 Warranty (for North America model only) ................................ 1

r

 Service station list ................................................................... 1

t

 Power cord (Cord length: Approx. 6.2 ft / 1.9 m) .................... 1

y

 Main remote control unit (RC-1126) ......................................... 1

u

 LR6/AA batteries (for RC-1126) ................................................ 2

i

 Sub remote control unit (RC-1121) .......................................... 1

o

 R03/AAA batteries (for RC-1121) ............................................. 2

Q0

 FM indoor antenna .................................................................. 1

Q1

 AM loop antenna (small, for AM broadcasts) .......................... 1

Q2

 AM loop antenna (large, for HD Radio broadcasts) ................. 1

Q3

 Dipole antenna (for HD Radio broadcasts) .............................. 1

Q4

 Rod antenna for wireless LAN connection .............................. 1

Q5

 Setup microphone 

  (DM-A409, Cord length: Approx. 25 ft / 7.6 m) ....................... 1

Check that the following parts are supplied with the product.

Thank  you  for  purchasing  this  DENON  product.  To  ensure  proper 
operation, please read this owner’s manual carefully before using the 
product. 
After reading them, be sure to keep them for future reference.

Point the remote control unit at the remote sensor when operating it.