Elite Video vsx33 ユーザーズマニュアル

En

Up to four receivers can be operated discretely using this 
receiver's remote control when using multiple receivers, 
provided they are of the same model as this receiver. The 
receiver to be operated is switched by inputting the 
preset code to set the remote control setting.

• Set the remote modes on the receivers before using 

this function (see Remote Control Mode Setup on 
page 87).

seconds.
The LED flashes continuously.

• To cancel the preset setup mode press R.SETUP.

1” to “Receiver 4”) you wish to operate.
For example, to operate “Receiver 2”, press “2”.

If the LED lights for one second, the setting has been 
successfully completed.

When the preset code is input, the LED flashes three 
times to indicate that the setting has failed.

Most components can be assigned to one of the input 
function buttons (such as DVD or CD) using the 
component’s manufacturer preset code stored in the 
remote.

However, there are cases where only certain functions 
may be controllable after assigning the proper preset 
code, or the codes for the manufacturer in the remote 
control will not work for the model that you are using.

If you can’t find a preset code that matches the 
component you want to control, you can still teach the 
remote individual commands from another remote 
control (see Programming signals from other remote 
controls on page 67).

• You can cancel or exit any of the steps by pressing 

R.SETUP.

• After one minute of inactivity, the remote 

automatically exits the operation.

• For greater convenience, assign the TV connected to 

the MONITOR OUT terminal to the TV CTRL button, 
and assign your satellite/cable receiver or set-top box 
connected to the TV input terminal to the TV input 
button. If a single device is connected to both 
terminals, that device should be assigned to both the 
TV CTRL and TV input buttons.

• Devices may be assigned to the following input 

function buttons.

seconds.
The LED flashes continuously.

• To cancel the preset setup mode press R.SETUP.

you want to control.
When assigning preset codes to TV CONTROL, press TV 
CTRL here.

The LED blinks once and flashes continuously.

code.
See Preset code list on page 104.

If the LED lights for one second, the setting has been 
successfully completed.

When the preset code is fully input, the LED flashes three 
times to indicate that the setting has failed. If this 
happens, enter the 4-digit preset code again.

you want to control.
To try out the remote control, switch the component on or 
off (into standby) by pressing 

 SOURCE. If it doesn’t 

seem to work, select the next code from the list (if there 
is one).

VSX-33_UXJCB.book  66 ページ  ２０１０年３月９日　火曜日　午前１０時３９分