Pentair 4/160 ユーザーズマニュアル

13

IntelliFlo 4 Installation and User’s Guide

The IntelliFlo 4 can be controlled by an IntelliTouch system via the RS-485 communication cable
(P/N 350122).  In this configuration, IntelliTouch 4 starts, stops and controls the speed of the IntelliFlo 4
pump. When the IntelliTouch does this, it rewrites the IntelliFlo 4 memory, which can take several seconds.
This causes a delay after a command is given on the IntelliTouch control panel until the Intelliflo 4 physically
responds.

The IntelliFlo 4 control panel is disabled when communicating with the IntelliTouch system.  Note that
IntelliTouch will not start communicating with the IntelliFlo 4 until the appropriate pump address is assigned
to a circuit.  The IntelliFlo 4 default pump address is one. See page 6 for details about how to check the
address and change if necessary.  For more information, refer to the IntelliTouch User's Guide (P/N
520102).

To connect the IntelliFlo 4 communication cable to IntelliTouch load center:

1.

2. Unlatch the IntelliTouch load center front door spring latches, and open the front door.

3. Remove the cover-panel screws securing the high voltage cover-panel, and remove it from the

enclosure.

4. Loosen the two control panel access screws and fold down the outdoor control panel.

5. Insert the two-wire cable into plastic grommet on the bottom of the enclosure and route the wire up

through the low voltage raceway to the Personality board.

IntelliTouch Load Center

Cover-panel

screw

(Cover-panel not

shown)

Access

screw

   

  

 

Personality Board

Low voltage raceway

Plastic grommet