Viking SLAL ユーザーズマニュアル

SECTION TSM 288

ISSUE

A

PAGE 28 OF  36

•  Install  the  L-cup  (8.01)  and  the  rotary  face  (8.02)  into  the 

rotor (2.01)

•  Install the O-ring (8.06) into the seal housing and then install 

the seal housing (8.10) into the casing 

•  Making sure that the location recesses line up with the seal 

washers (8.08) see Figure 47 and Figure 44

•  Install the O-ring (8.04) onto the static seal (8.03) and then 

install the static seal into the casing – Make sure that the 

location slots line up with the pins in the seal housing

The seals are now assembled.
For rotor and head installation see pump assembly section.

•  Install the slinger (5.15)

NOTE: the slinger has raised sections on the internal diameter, 

which press onto the shaft.
•  Install the O-ring (8.19) into the sleeve (8.11) and then install 

the assembly onto the shaft.

NOTE: There are two drive slots in the shaft which must be 

lined up with the drive pins on the  sleeve. 
NOTE: The SLA utilizes four grub screws instead of the drive 

pins to locate the housing onto the shaft
•  Install  the  guard  (7.03)  and  casing  (3.01)  and  secure  with 

screws (4.07) (See section 6.2 for torque settings)