Panasonic WJ-HD716K/G ユーザーズマニュアル

62

When connecting the recorders (up to 5 recorders) in cascading connection, all images managed by the con-
nected recorders can be monitored on a single monitor. 
The following are descriptions of how to operate when the recorders are connected in cascading connection. To 
operate the recorders connected in cascading connection, it is necessary to configure the settings in advance. 
Refer to the Installation Guide for further information.

 •  Audio cables can also be connected in cascading connection.
 

Configure the settings required for cascading connection. Operations and settings of the WJ-HD716K are the 
same as that of the WJ-HD616K.

Select "On" for "Cascade" on the "Cascade" tab under "Display" of the setup menu of the recorder to be con-
nected in cascading connection. Set the unit addresses of recorders as follows. 

First recorder

001

Select a number except 001 - 004 and not used 
for the other devices.

Second recorder

002

Third recorder

003

Fourth recorder

004

Fifth recorder

005

Set the unit addresses of system controllers as follows. 

First system controller

001

It is possible to operate all monitor 1 and monitor 
2 connected to the first through fifth WJ-HD616K.

Second system controller

002

Monitor 1 and monitor 2 connected to the first 
through the fifth WJ-HD616K are available to oper-
ate. However, camera selection on monitor 2 is 
unavailable. 

Third system controller

003

Fourth system controller

004