Panasonic WJ-HD716K ユーザーズマニュアル
29
Connection of cameras
Up to 16 cameras (system cameras or combination cameras) can be connected to the video input connector 1-16.
Important:
• When using with a Panasonic's matrix switcher or a coaxial communication unit, make sure that the loop-through output
connection (of each video input) to the recorder are correctly made. When a monitor output or a spot output is connected to
the video input connector of the recorder, noise may be produced upon switching camera channels or images of few sec-
onds before switching camera channels may be displayed/recorded. When a monitor output or a spot output is connected to
the video input connector of the recorder, noise may be produced upon switching camera channels or images of few sec-
onds before switching camera channels may be displayed/recorded.
the video input connector of the recorder, noise may be produced upon switching camera channels or images of few sec-
onds before switching camera channels may be displayed/recorded. When a monitor output or a spot output is connected to
the video input connector of the recorder, noise may be produced upon switching camera channels or images of few sec-
onds before switching camera channels may be displayed/recorded.
• Connect the power plug of the recorder at the very end of connections.
• When connecting combination cameras to the WJ-HD616K, connect them to the video input connector 1 - 8 (coaxial con-
• When connecting combination cameras to the WJ-HD616K, connect them to the video input connector 1 - 8 (coaxial con-
nection compatible).
• It is impossible to connect a VCR to the video input connector.
Mode switch setting (default)
Note:
• When not using the DATA port and the RS485 port, do not change the setting from the default.
Connections
Combination cameras
(Video input connector 1 - 8)
System cameras
(Video input connector 9 - 16)
EXT STORAGE
MODE
DATA
RS485(CAMERA) 10/100BASE-T
ALARM
VIDEO
OUT-CASCADE-IN
ALARM/CONTROL
CASCADE IN
MONITOR
OUT
OUT MONITOR OUT(HD)
AUDIO IN
AUDIO
OUT
3
2
1
1 2 3 4 5 6 7 8
1
2
3
4
4
2
3
1
1
2
5
6
7
8
9
10
11
12
13
14
15
16
IN
OUT
2
1
3
4
5
6
7
7
1
2
1
2
8
9
10
11
12
13
14
15
16
POWER
AC IN
SIGNAL
GND
ON
OFF
OUT
IN
OUT
CASCADE
1
2
• • •
• • •
6 7 8
1 2 3 4 5
ON
Amplifier
Microphone
Mode switch setting (default)
Note: When not using the DATA port and the RS485
port, do not change the setting from the default.
Recorder